Do not let sticky surface of pads touch each other as you may not be able to separate them. Remove pads gently from the storage sheets. Connect them to the electrode wire(s) and connect the wire(s) to the Advanced Foot Energizer (see Body Electrode Wire Outlets in diagram above). You will need to use either two or four pads.
Ipulse tens and electric muscle stimulator instructions skin#
Prepare your skin by cleaning with soap and water or with a cloth.Please adjust the intensity gradually from weaker to stronger. Most of our customers feel that an intensity level beginning with 40+ is sufficient. Please do not proceed directly to the highest level of 99, instead find the strongest level that is comfortable for you. If you feel pain or discomfort remove one or both feet from the foot pads to stop the stimulation and then lower the intensity of the stimulation by using the “SOLE ” on the control panel or the remote control before replacing your feet on the Advanced Foot Energizer.When you are ready to finish your massage, please turn off the massager by pressing and holding the ON/OFF button until the LCD panel goes out.This is to protect the user from potential sudden increases in stimulation while changing modes. You may adjust the modes at any time, but please be aware that once you change the mode, the intensity will return to zero.You may increase the intensity by pushing the “SOLE ” repeatedly or decrease the intensity by pushing “SOLE ” button.Modes 1 -8 are for EMS and Modes 9-25 are for TENS. Next you may adjust the pre-programed modes by pressing “MODE ” or “MODE ” to select different modes.Press and hold the ON/OFF button until the LCD screen lights up.If skin is dry then dampen lightly with non-oily gel or water) (Make sure the surface of your feet are clean and oil free. Place your bare feet on the correct left and right foot pads. Remove all footwear including socks or stockings.
0 kommentar(er)
